Brother NX-200 Manuel d'utilisateur Page 50
- Page / 111
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
SEWING BASICS ———————————————————————————————————————————————————————
—
44
GETTING READYCONTENTS SEWING BASICS UTILITY STITCHES APPENDIX INDEX
Adjusting the Thread Tension
The tensions of the upper thread and of the bobbin thread (thread tension) should be adjusted so that they are
equal.
Changing the tension of the
upper thread
If the thread and needle combination is correct for
the type of fabric being sewn (according to “Needle
types and their uses” on page 26), the thread tension
will automatically be adjusted to the appropriate
setting. However, if the preset thread tension does
not give the desired result or if you are sewing with
special thread or on special fabric, use the thread
tension dial under the upper cover to adjust the
tension of the upper thread.
■ Correct thread tension
The upper thread and the bobbin thread should
cross near the center of the fabric. Only the upper
thread should be visible from the right side of the
fabric, and only the bobbin thread should be
visible from the wrong side of the fabric.
1 Wrong side of fabric
2 Right side of fabric
3 Upper thread
4 Bobbin thread
■ Upper thread is too tight
If the bobbin thread is visible from the right side
of the fabric, the upper thread is too tight.
1 Wrong side of fabric
2 Right side of fabric
3 Upper thread
4 Bobbin thread
5 The bobbin thread is visible from the right side of
the fabric.
Turn the thread tension dial to the left to loosen
the upper thread.
■ Upper thread is too loose
If the upper thread is visible from the wrong side
of the fabric, the upper thread is too loose.
1 Wrong side of fabric
2 Right side of fabric
3 Upper thread
4 Bobbin thread
5 The upper thread is visible from the wrong side of
the fabric.
Turn the thread tension dial to the right to tighten
the upper thread.
1
2
3
4
1
2
3
4
5
5
1
2
3
4
F0_brotherE.book Page 44 Wednesday, May 21, 2003 11:38 AM
- Enclosed Accessories 2
- Front view 3
- Needle and presser foot 4
- Right-side/rear view 4
- Operation buttons 5
- Operation panel 6
- Optional Accessories 7
- Introduction 8
- Sewing Machine Features 8
- Contents 9
- SAVE THESE INSTRUCTIONS 12
- Important Safety Instructions 12
- IMPORTANT 13
- GETTING READY 15
- Turning the Machine On/Off 16
- Turning on the machine 17
- Turning off the machine 17
- Winding/Installing the Bobbin 18
- 1 Sewing speed controller 21
- 1 Start/stop button 21
- Installing the bobbin 22
- Upper Threading 24
- Upper Threading 19 25
- Threading the needle 27
- Using the twin needle 28
- Upper Threading 23 29
- Using thread that winds off 30
- Pulling up the bobbin thread 31
- Replacing the Needle 32
- Checking the needle 33
- Replacing the needle 34
- Replacing the Presser Foot 35
- Adjusting the pressure of 36
- Removing the presser foot 37
- Using the optional walking 37
- 1 Needle position button 38
- 1 Presser foot lever 38
- Stitching cylindrical pieces 39
- Sewing large pieces of fabric 39
- SEWING BASICS 41
- General sewing procedure 43
- Positioning the fabric 44
- Starting to sew 45
- Securing the stitching 47
- Cutting the thread 49
- Adjusting the Thread Tension 50
- Adjusting the stitch width 51
- Adjusting the stitch length 52
- Useful Functions 53
- Useful Sewing Tips 55
- Sewing thick fabrics 56
- Sewing thin fabrics 57
- Sewing stretch fabrics 57
- Sewing an even seam 57
- UTILITY STITCHES 59
- Selecting Stitching 60
- Selecting Stitching 55 61
- Overcasting Stitches 62
- Overcasting Stitches 57 63
- 1 2 cm (1/16 inch) 65
- 1 Guide plate 65
- 1 5 mm (3/16 inch) 65
- Basic Stitching 66
- Blind Hem Stitching 67
- Buttonhole Stitching 69
- Buttonhole sewing 70
- Buttonhole Stitching 65 71
- Button sewing 73
- 1 Button 74
- 1 Back side 74
- Buttonhole Stitching 69 75
- Zipper Insertion 76
- Inserting a side zipper 77
- Zipper Insertion 73 79
- Stretch stitching 80
- Elastic attaching 80
- Appliqué stitching 83
- Patchwork (crazy quilt) 84
- Quilting 85
- Free-motion quilting 86
- 1 Feed dog position switch 87
- 2 Back side 87
- 1 Pattern 87
- Reinforcement Stitching 88
- Reinforcement Stitching 83 89
- Eyelet Stitching 90
- Decorative Stitching 91
- Fagoting 92
- Scallop stitching 93
- Smocking 93
- Heirloom stitching 95
- 1 4 mm (3/16 inch) 96
- APPENDIX 97
- Stitch Settings 98
- Stitch Settings 93 99
- Stitch Settings 95 101
- Maintenance 102
- Troubleshooting 104
- Error messages 107
- Operation beep 108
- Removing the upper cover 108
- XC4665-0511 111
- Printed in Taiwan 111
Produits connexes et manuels pour Machines à coudre Brother NX-200
(90 pages)
(146 pages)
(2 pages)
© 2020, manymanuals.fr. Tous droits réservés | 4.007 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels