Brother HL-4200CN Manuel d'utilisateur télécharger pdf (Page 57)

10 - 3 TROUBLESHOOTING

Intermittent Problems

If the print server and printer start up OK, but you intermittently have problems printing, check the

following:

If you can print small jobs but large graphics jobs are distorted or incomplete, make sure that you

have adequate memory in your printer and the latest printer driver installed on your computer. The

latest Brother printer drivers can be downloaded from http://solutions.brother.com

Check the individual protocol troubleshooting sections in this chapter for additional causes of

intermittent printer problems.

TCP/IP Troubleshooting

If you are using TCP/IP and cannot print to the print server and you have checked the hardware and

network as described in the previous steps, then check the following:

It is always a good idea to try following in order to eliminate the possibility of setup errors.

Turning off the printer and then again,

Deleting and recreating the print server and creating a new print queue in order to eliminate the

possibility of setup errors.

The problem may be the result of mismatched or duplicate IP address.

Verify that the IP address is correctly loaded into the print server (via the printer settings page.)

Make sure that no other nodes on the network have this address (DUPLICATE IP ADDRESS ARE

THE BIGGEST CAUSE OF TCP/IP PRINTING PROBLEMS).

Make sure that the TCP/IP protocol of the print server is enabled.

Verify that host computer and the print server are either on the same subnet, otherwise that the

router is properly configured to pass data between the two devices.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 63

Pas de commentaire

Brother HL-4200CN Manuel d'utilisateur Page 57