Brother HL-4200CN Manuel d'utilisateur télécharger pdf (Page 25)

2 - 5 TCP/IP PRINTING

Refer to How to configure TCP/IP printing for UNIX system for more information on Service Names.

Click on Close. The new print server IP address should be listed and highlighted as an available

port. Click on Next.

Select the desired printer model. If the correct model is not displayed, click on the Have Disk option

and insert the CD-ROM supplied with your printer.

If the driver already exists, select Keep Existing Driver (if it does not, this step will be skipped), and

then click on Next.

If desired, change the name of the printer then click on Next.

If desired, make the printer shared (so other users can access it), and select the operating system(s)

that the other computers will be running. Click on Next.

Select Yes when you are asked “Would you like to print a test page?” Click on Finish to complete

the installation. You may now print to the printer as if it were a local printer.

Windows

NT 4.0 Printing (Printer Driver already installed)

Follow these steps if the printer driver is already installed.

Click on Start then select Settings/Printers to display the currently installed printer drivers.

Double click the printer driver you wish to configure and select Printer menu and then choose

Properties.

Select the Ports tab and click on Add Port.

Select LPR Port (LPR Port will not be displayed unless you install the “Microsoft TCP/IP Printing”

protocol as described earlier) from the list of available ports and click on New Port.

Type in the IP address that you assigned to the print server in the Name or address of server

providing lpd: box. If you have edited your HOSTS file or are using Domain Name System, you can

enter the name associated with the print server, instead of an IP address. As the print server

supports TCP/IP and NetBIOS names, you can also enter the NetBIOS name of the print server.

The NetBIOS name can be seen in your printer settings page. From default the NetBIOS name will

usually appear as “BRN_xxxxxx” where xxxxxx is the last six digits of the Ethernet address.

Type in the print server service name in the Name of printer or print queue on that server: box. If

you do not know which service name to use, enter BINARY_P1 and then click on OK.

Click on the Close button.

You should now see that the printer driver is configured to print to the IP address (or name) that you

specified.

If you wish to share the printer, click on the Sharing tab and share the driver.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 62 63

Pas de commentaire

Brother HL-4200CN Manuel d'utilisateur Page 25