Brother HL-4200CN Manuel d'utilisateur télécharger pdf (Page 15)

1 - 5 UNIX PRINTING

If you are using the HP distributed print service, the configuration procedure is slightly different because

you are sending the print jobs to a file server, which in turn spools the job to the print server. You must

therefore know the name of the file server (spooler host) in addition to the above information. You will

add a physical and a remote printer, and then assign a logical printer to the remote printer (a unique

name that does not match any other name). To print, use the lp -d command with the logical printer

name.

Earlier versions of HP/UX use similar procedures to 10.xx users:

Enter sam and select Peripheral Devices and then Add Remote Printer (not Networked printer).

Enter the following remote printer settings (the other settings do not matter):

■ Line printer name (user-selectable).

■ Remote system name (the print server name; must match what is in hosts file or use print

server IP address).

■ Remote printer queue (We recommend using “BINARY_P1” for the queue name).

■ Remote Printer is on a BSD System (Yes).

IBM RS/6000 AIX Configuration

The RS/6000 AIX operating system uses the smit program to set up the remote printer. The procedure

is as follows for AIX 4.0 and later:

Enter smit and select devices.

Select Printer/Plotter.

Select Print Spooling.

Select Add a Print Queue.

Select Remote.

Enter the following Remote Printer Settings:

■ Name of queue (user selectable)

■ Host name of Remote Printer (print server name; must match name in /etc/hosts file or use

the print server IP address)

■ Name of queue on remote printer (We recommend using “BINARY_P1” for the queue name).

■ Type of print spooler. BSD (press the LIST button and choose BSD)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 62 63

Pas de commentaire

Brother HL-4200CN Manuel d'utilisateur Page 15