Brother HL 1270N Manuel d'utilisateur télécharger pdf (Page 35)

2-10

LAN Server, OS/2 Warp Server Configuration

Brother Print Servers will work with IBM LAN Server, OS/2 Warp Server networks that have

IBM TCP/IP V2.0 or later installed on the file server (TCP/IP is supplied as standard with

LAN Server V4.0 and later as well as Warp Server). Use the following procedure to configure

the print server on an LAN Server or OS/2 Warp Server file server, or on a OS/2 Warp

Connect workstation:

Server Configuration

Make sure that TCP/IP software is installed on your OS/2 file server. If you have not already

done so, open the TCP/IP folder on the desktop, and double click on the TCP/IP

Configuration icon to add the IP address to the OS/2 file server (consult your system

manager for this address).

Programming an IP address for the print server

1. If you have the computer on where the BRAdmin32 for Windows 95/98/NT4.0

workstation, it is easiest to use the BRAdmin32 to configure the IP address for the

print server, otherwise go to step2.

2. At the OS/2 prompt, use the "arp -s” command from the DOS prompt to enter the IP

address into the Brother Print Server as shown in the following example. If your

printer does have an LCD display, use the front panel buttons to configure the IP

address as described in the Quick Setup Guide.

arp -s 192.189.207.77 00:80:77:31:01:07 temp

Substitute the IP address of the Brother Print Server that you wish to use and replace

'00:80:77:31:01:07' with the actual Ethernet address (MAC Address) of the

Brother Print Server. Note that you should use colons rather than hyphens to separate

the bytes of the hardware address.

✒

Note

You can find the MAC address by printing out the printer configuration page. Refer to the

Quick Setup Guide for information on how to print the configuration page on your print server.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 121 122

Pas de commentaire

Brother HL 1270N Manuel d'utilisateur Page 35