Brother HL 1270N Manuel d'utilisateur télécharger pdf (Page 17)

IP Address Configuration

The final step before printing is to program the IP address information into the print server.

This can be done in any of the following ways:

a) BRAdmin32 (for Windows 95/98/NT 4.0 using the IPX/SPX or TCP/IP protocol)

b) DHCP, Reverse Arp (rarp), BOOTP

c) The UNIX arp command.

The following step (e, f, g) is effective way, when you change IP address. But a valid IP

address must already be programmed into the print server.

d) TELNET

e) HTTP (Web browser)

f) Other SNMP based management utility

These configuration methods are described in the following paragraphs.

✒ Note

The IP address you assign to the print server must be on the same logical network as your host

computers, if it is not, you must properly configure the subnet mask and the router (gateway).

Changing the IP Address using the BRAdmin32 application

Start the BRAdmin32 utility (from Windows 95/98 or NT4.0).

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 121 122

Pas de commentaire

Brother HL 1270N Manuel d'utilisateur Page 17