Brother MFC-J5320DW Guide de l'utilisateur télécharger pdf (Page 73)

Troubleshooting

65

B

Dial Tone detection B

When sending a fax, by default your machine

will wait for a fixed amount of time before it

starts to dial the number. By changing the

Dial Tone setting to Detection, you can

make your machine dial as soon as it detects

a dial tone. This setting can save time when

sending a fax to many different numbers. If

you change the setting and start having

problems when dialling, you should change it

back to the No Detection setting.

a Press (Settings).

b Press All Settings.

c Press a or b to display

Initial Setup.

d Press Initial Setup.

e Press a or b to display Dial Tone.

f Press Dial Tone.

g Press Detection or No Detection.

h Press .

Telephone Line Interference

or VoIP System B

If you are having problems sending or

receiving a fax due to possible interference

on the telephone line, or if you are using a

VoIP system, we recommend that you

change the modem speed to minimise errors

in fax operations.

a Press (Settings).

b Press All Settings.

c Press a or b to display

Initial Setup.

d Press Initial Setup.

e Press a or b to display

Compatibility.

f Press Compatibility.

g Press Normal or Basic(for VoIP).

 Basic(for VoIP) reduces the

modem speed to 9,600 bps and

turns off colour fax receiving and

Error Correction Mode (ECM),

except for colour fax-sending.

Unless interference is a recurring

problem on your telephone line, you

may prefer to use it only when

needed.

To improve compatibility with most

VoIP services, Brother recommends

changing the compatibility setting to

Basic(for VoIP).

 Normal sets the modem speed at

14,400 bps.

h Press .

NOTE

VoIP (Voice over IP) is a type of phone

system that uses an Internet connection,

rather than a traditional phone line.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 79 80

Commentaires sur ces manuels

Pas de commentaire