Brother DCP-J140W Manuel d'utilisateur télécharger pdf (Page 26)

Network menu 4

The 3.Network menu selections of the control panel allow you to set up the Brother machine for your

network configuration. Press Menu, then press a or b to choose 3.Network. Proceed to the menu selection

you wish to configure. (See Function table and default factory settings uu page 29.)

Please note that the machine is supplied with the BRAdmin Light utility which can also be used to configure

many aspects of the network. (See Using the BRAdmin Light utility uu page 2.)

TCP/IP 4

BOOT Method 4

This selection controls how the machine obtains an IP address.

Auto mode 4

In this mode the machine will scan the network for a DHCP server. If it can find one, and if the DHCP server

is configured to allocate an IP address to the machine, then the IP address supplied by the DHCP server will

be used. If no DHCP server is available, then the machine will scan for a BOOTP server. If a BOOTP server

is available, and it is configured correctly, the machine will take its IP address from the BOOTP server. If a

BOOTP server is not available, the machine will scan for a RARP server. If a RARP server is also not

available, the IP Address is set using the APIPA protocol. After the machine is initially powered ON, it may

take a few minutes for the machine to scan the network for a server.

Static mode

In this mode the machine’s IP address must be manually assigned. Once entered the IP address is locked to

the assigned address.

Note

If you do not want your print server configured via DHCP, BOOTP or RARP, you must set the

1.BOOT Method to Static so that the print server has a static IP address. This will prevent the print

server from trying to obtain an IP address from any of these systems. To change the 1.BOOT Method,

use the machine’s control panel or BRAdmin Light utility.

Control panel setup 4

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 40 41

Pas de commentaire

Brother DCP-J140W Manuel d'utilisateur Page 26