Brother XT37 Manuel d'utilisateur télécharger pdf (Page 23)

—————

——————————————————————————————————————————————————————————————————————————

—

————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————

Pull the loop of the thread passed through

the eye of the needle toward the rear of

the machine.

1 Loop of thread

CAUTION

Note

● Needle threader cannot be used when using

the twin needle. In this case, thread the

needle as described below.

Raise the presser foot lever.

Pass the end of the thread through the

presser foot, and then pull out about 5 cm

(2 inches) of thread toward the rear of the

machine.

1 5 cm (2 inches)

Note

● If you incorrectly feed the thread you may

cause sewing problems.

Drawing up the lower

thread

You can begin sewing immediately without drawing up

the bobbin thread.

When sewing gathers or darts, you can draw up the

lower thread by hand so that some thread will be left

over. Before you draw up the lower thread, put the

bobbin back in.

Raise the presser foot lever.

Remove the bobbin cover, and then

reinstall the bobbin.

Pass the thread along the slit in the

direction of the arrow, and leave it there

without cutting it.

• The bobbin cover should still be removed.

●

Be careful not to pull on the thread with

force or it may bend the needle.

● If the thread does not pass through the

eye of the needle, start from step

again.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

Brother XT37 Manuel d'utilisateur Page 23

Commentaires sur ces manuels

Produits connexes et manuels pour Machines à coudre Brother XT37