Brother XT37 Manuel d'utilisateur Page 17

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 52
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 16
16
1
b
Press the foot controller to start.
c
When the bobbin seems full and begins
spinning slowly, take your foot off the foot
controller.
CAUTION
d
Cut the thread, slide the bobbin winder
shaft to the left, and then remove the
bobbin from the shaft.
Note
When the sewing machine is started or the
handwheel is turned after winding the
thread around the bobbin, the machine will
make a clicking sound; this is not a
malfunction.
The needle bar does not move when you
slide the bobbin winder shaft to the right.
CAUTION
Lower threading
Install the bobbin wound with thread.
CAUTION
1
Prepare the bobbin wound properly
before threading the lower thread.
See page 13 for the details about bobbin
winding.
2
Raise the needle by turning the
handwheel toward you
(counterclockwise) and raise the presser
foot lever.
3
Remove the bobbin cover by sliding it and
lift toward you.
1 Bobbin cover
4
Put the bobbin in so the thread comes out
in the direction shown by the arrow.
CAUTION
When the bobbin winding becomes
slow, stop the machine, otherwise the
sewing machine may be damaged.
Not winding the bobbin properly may
cause the thread tension to loosen, and
may break the needle.
1 Wound evenly
2 Wound poorly
1
2
Make sure you turn off the machine
while threading. If you accidentally step
on the foot controller and the machine
starts to sew, you could be injured.
Make sure you set the bobbin so the
thread unrolls in the right direction. If
the thread unrolls in the wrong
direction, it may cause the thread
tension to be incorrect or break the
needle.
1
Vue de la page 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 51 52

Commentaires sur ces manuels

Pas de commentaire