Brother NX-200 Manuel d'utilisateur télécharger pdf (Page 55)

Useful Sewing Tips 49

Useful Sewing Tips

Various ways to achieve better results for your sewing projects are described below. Refer to these tips when

sewing your project.

Trial sewing

After you have set up the machine with the thread

and needle appropriate for the type of fabric being

sewn, the machine automatically sets the thread

tension and stitch length and width for the stitch that

is selected. However, a trial piece of fabric should be

sewn since, depending on the type of fabric and

stitching being sewn, the desired results may not be

achieved.

For the trial sewing, use a piece of fabric and thread

that are the same as those used for your project, and

check the thread tension and stitch length and width.

Since the results differ depending on the type of

stitching and the number of layers of fabric sewn,

perform the trial sewing under the same conditions

that will be used with your project.

Changing the sewing

direction

When the stitching reaches a corner, stop the

sewing machine.

Leave the needle lowered (in the fabric). If the

needle remained up when the machine

stopped sewing, press (needle position

button) to lower the needle.

Raise the presser foot lever, and then turn the

fabric.

Turn the fabric using the needle as a pivot.

Lower the presser foot lever and continue

sewing.

Sewing curves

Stop sewing, and then slightly change the sewing

direction to sew around the curve. For details on

sewing with an even seam allowance, refer to

“Sewing an even seam allowance” (page 51).

When sewing along a curve while using a zigzag

stitch, select a shorter stitch length in order to obtain

a finer stitch.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 110 111

Pas de commentaire

Brother NX-200 Manuel d'utilisateur Page 55