Brother NX-200 Manuel d'utilisateur télécharger pdf (Page 38)

GETTING READY ——————————————————————————————————————————————————

—

Note

● When sewing with the walking foot, sew at

a speed between slow and medium.

■ Removing the walking foot

Press (needle position button) once or

twice to raise the needle.

1 Needle position button

X The needle is raised.

Turn off the sewing machine.

Raise the presser foot lever.

1 Presser foot lever

X The presser foot is raised.

With a screwdriver, loosen the presser foot

holder screw, and then remove the walking

foot.

Attach the presser foot holder.

• For details, refer to “Removing the presser

foot holder” (page 31).

Memo

● Only the straight stitch (with reinforcement

stitching) and the zigzag stitch can be used

with the walking foot. For details on the

stitches, refer to “Stitch Settings” (page 92).

Note

● The optional walking foot is available

through your brother retailer.

●

Be sure to securely tighten the screw

with the screwdriver, otherwise the

needle may touch the presser foot,

causing it to bend or break.

●

Before starting to sew, slowly turn the

balance wheel toward you and check

that the needle does not touch the

presser foot. If the needle hits the presser

foot, the needle may bend or break.

CAUTION

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 110 111

Pas de commentaire

Brother NX-200 Manuel d'utilisateur Page 38