Brother HL-1040 Manuel d'utilisateur Page 76

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 305
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 75
IV-9
I-5 Dirt on the back of paper
Possible cause Step Check Result Remedy
Fixing unit 1 Is the pressure roller dirty?
Is any other area in the printer
dirty?
Yes Clean the pressure roller.
(See the following note.)
Dirt in the drum
unit
2 Is the transfer roller dirty?
Is the problem solved after the
drum unit is replaced?
Yes Replace the drum unit
No Replace the high-voltage
power supply PCB.
Note: Clean the pressure roller as follows;
(1) Set three or more sheets of paper in the MP sheet feeder.
(2) Open the top cover.
(3) Turn on the power switch while holding down the switch on the control panel.
(4) Release the panel switch when the Drum lamp is on.
(5) Close the top cover.
(6) Hold down the panel switch until the Ready lamp is on, then release the
switch.
(7) Print three patterns; grid, zip and solid black.
(8) Turn off the power switch with the top cover closed.
(9) Set paper in the manual slot with the solid black side up.
(10) Turn on the power switch while holding down the switch on the control panel.
(11) Release the panel switch when the Drum lamp is on.
(12) Press the panel switch again and release it immediately.
(13) Print a page of test pattern while cleaning the pressure roller.
Vue de la page 75
1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 304 305

Commentaires sur ces manuels

Pas de commentaire