Brother HL-1040 Manuel d'utilisateur Page 198
- Page / 305
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
- 24 -
REPLACING THE TONER CARTRIDGE
The printer can print approximately 2,400 pages (5% coverage: A4/Letter) with one toner
cartridge. When the toner cartridge is running low, the
Alarm
and
Data
(Toner) lamps blink
once every 5 seconds to indicate toner low.
Initially, some models are supplied with a
starter toner cartridge which must be replaced after 1,000 pages.
✒
✒✒
✒
Note
Actual page count will vary depending on your average document type. (i.e.:
standard letter, detailed graphics, etc.)
It is recommended that you always keep a new toner cartridge ready for use for when
you get the toner low warning.
Discard the used toner cartridge according to local regulations. If you are not sure of
them, consult your local dealer. Be sure to seal up the toner cartridge tightly so that
toner powder does not spill out of the cartridge. Do not discard used toner cartridges
together with domestic rubbish.
It is recommended that you clean the printer when you replace the toner cartridge.
Drum
Alarm
Ready
Paper
Data
Toner
Toner Low and Empty Indication
!
Caution
You may print approximately 100 pages after the first toner low indication. Both
Alarm
and
Data
(Toner) lamps will blink continuously to indicate that the toner is
empty. Once this indication appears, your printer cannot resume printing until you
have installed a new toner cartridge.
Keep the drum unit level after removing the toner cartridge, to avoid
possible toner spill or scatter.
Follow these steps to replace the toner cartridge:
1
Open the top cover towards you. Remove
the drum unit by holding each side of the
drum and gently lifting the drum forwards
towards you.
✒
Note
It is recommended to put the drum unit on a
piece of disposable paper or cloth in case of
accidental toner spill or scatter.
- APPENDICES 6
- 1. FEATURES 7
- 2. SPECIFICATIONS 9
- 69.8 to 229 mm 11
- 105 to 356mm (face down) 11
- Feeding direction 11
- 2.7 Effective Printing Area 13
- Printable area 13
- 3. SAFETY INFORMATION 15
- Fig. 1-1 16
- Fig. 1-2 16
- 1. ELECTRONICS 17
- Low-voltage power 18
- supply block 18
- High-voltage power 18
- supply block 18
- 1.2 Main PCB Block Diagram 20
- HL-820/1020 20
- Fig. 2-5 21
- Fig. 2-6 22
- Fig. 2-7 23
- Fig. 2-8 24
- CPU Receive Mode 26
- DMA Receive Mode 26
- (11) Engine control I/O 27
- Fig. 2-11 31
- Fig. 2-12 31
- Fig. 2-13 32
- Fig. 2-14 32
- Fig. 2-15 33
- Fig. 2-16 34
- Fig. 2-17 34
- Fig. 2-18 34
- Fig. 2-19 35
- Fig. 2-20 35
- Fig. 2-21 35
- Fig. 2-22 36
- 1.3.10 Engine I/O 37
- HL-820/1020/1040 37
- Fig. 2-24 38
- Fig. 2-25 39
- Fig. 2-26 39
- Fig. 2-27 40
- Fig. 2-28 41
- 2. MECHANICS 42
- 2.5.2 Exposure Stage 47
- 1. SAFETY PRECAUTIONS 50
- 2. DISASSEMBLY FLOW 51
- 3. DISASSEMBLY PROCEDURE 52
- 3.5 MP Sheet Feeder ASSY 54
- 3.7 Scanner Unit 57
- Caution: 59
- 3.10 Panel Sensor PCB ASSY 60
- (1) Remove the main shield 60
- 3.15 Drive Unit 64
- PR980109 64
- 4. PACKING 67
- 1. INTRODUCTION 68
- 2. CONSUMABLE PARTS 70
- 3. IMAGE DEFECTS 71
- I-1 Light 72
- I-2 Dark 73
- I-3 Completely blank 74
- I-4 All black 75
- I-5 Dirt on the back of paper 76
- (Fig.4-5) 77
- I-9 White vertical streaks 78
- I-10 Faulty registration 78
- I-11 Poor fixing 79
- I-12 Image distortion 79
- I-13 Faint print 80
- I-14 White spots 80
- I-15 Black spots 81
- I-16 Black band 82
- I-17 Gray background 83
- I-18 Hollow print 83
- I-20 Horizontal lines 84
- I-21 Light rain 85
- I-22 Ghost 85
- Fig. 4-7 87
- Feed shaft roller 87
- For feed roller 87
- 4. PAPER JAM 88
- P8-1 P8-4 Approx. 24V 89
- P8-2 P8-3 Approx. 5V 89
- M-3 Main motor unrotated 90
- M-4 No paper supplied 90
- M-7 BD failure 91
- M-8 Scanner failure 92
- F-1 Double feeding 93
- F-2 Wrinkles 93
- 6. INSPECTION MODE 94
- Fig. 4.8 95
- Fig. 4-9 96
- SERIAL I/F 100
- CODE UK4007000 101
- B48K312CIR 101
- CODE UK4041000 103
- B512001CIR 103
- CODE UK4010000 108
- B48K303CIR 108
- Low-voltage 109
- PS Circuit (110 - 120V) 109
- PS Circuit (220 - 240V) 110
- High-voltage PS CircuitNAME 113
- Drum Life 115
- 00000030303030202 115
- PARTS REFERENCE LIST 117
- B48K056 - 201A 118
- CONTENTS 119
- (Legend model only) 120
- T/I NO. PR98176 123
- MODEL: LT-24CL 133
- MODEL LT-24CL 54S-X06 137
- REGULATIONS 142
- CLASS 1LASER PRODUCT 143
- APPAREIL Å LASER DE CLASSE 1 143
- LASER KLASSE 1 PRODUKT 143
- SAFETY INSTRUCTIONS 144
- 1. PRODUCT OUTLINE 148
- 2. SPECIFICATIONS 149
- 3. INSTALLATION 150
- 3.2 Unpacking 151
- 3.3 Installation Procedures 152
- INSTALLATION 153
- 4. MAINTENANCE 157
- 5. DISASSEMBLY 158
- 5.2 Paper Size Sensor (PSU) 159
- 5.3 Paper Feeding Clutch 159
- DISASSEMBLY 160
- 6. CLEARING PAPER JAMS 161
- GENERAL DRAWING 162
- Quick Setup Guide 173
- To Use the Printer Safely 174
- Action 2: Place the printer 177
- Starter Sheet 178
- Troubleshooting 184
- Printing a Test Sample Page 186
- LAMPS AND SWITCH 195
- REPLACING THE TONER CARTRIDGE 198
- REPLACING THE DRUM UNIT 201
- ALARM INDICATIONS AT A GLANCE 204
- PRINTER SPECIFICATIONS 209
- Disconnect device 212
- For Finland and Sweden 212
- LUOKAN 1 LASERLAITE 212
- KLASS 1 LASER APPARAT 212
- Re-pack the printer 213
- HL-800/1000 Series 215
- TABLE OF CONTENTS 216
- Inside the Printer 218
- Shipment of the Printer 219
- CHAPTER 1 221
- INTRODUCTION 221
- ABOUT YOUR PRINTER 222
- Features 223
- Power Supply 227
- Environment 227
- CHAPTER 2 229
- PAPER HANDLING 229
- USER’S GUIDE 230
- CHAPTER 2 PAPER HANDLING 231
- Fig. 2-1 Fan the Paper and 231
- Straighten the Paper 231
- Fig. 2-2 Envelopes 232
- Fig. 2-3 Printable Area 232
- MULTI-PURPOSE SHEET FEEDER 233
- MANUAL FEED SLOT 237
- CHAPTER 3 240
- CONTROL PANEL 240
- CHAPTER 3 CONTROL PANEL 242
- CHAPTER 4 244
- CHAPTER 4 OPTIONS 246
- MAINTENANCE 253
- CHAPTER 5 253
- CHAPTER 5 MAINTENANCE 255
- Fig. 5-3 Inside the Printer 255
- Fig. 5-13 Inside the Printer 260
- CLEANING THE PRINTER 263
- Fig. 5-21 Inside the Printer 264
- Scanner Window 265
- RE-PACKING THE PRINTER 267
- CHAPTER 6 269
- TROUBLESHOOTING 269
- CHAPTER 6 TROUBLESHOOTING 271
- PAPER JAMS 273
- Q & A 276
- Print Quality 282
- CHAPTER 7 285
- APPENDIX 285
- CHAPTER 7 APPENDIX 287
- RESIDENT FONTS 291
- SYMBOL SETS/CHARACTER SETS 293
Produits connexes et manuels pour Imprimeurs Brother HL-1040
Imprimeurs Brother 580C Manuel d'utilisateur
(188 pages)
(188 pages)
Imprimeurs Brother DCP 1000 Manuel d'utilisateur
(129 pages)
(129 pages)
Imprimeurs Brother DCP8020 Manuel d'utilisateur
(282 pages)
(282 pages)
(36 pages)
Imprimeurs Brother DCP 8060 Manuel d'utilisateur
(116 pages)
(116 pages)
Imprimeurs Brother DCP-115C Manuel d'utilisateur
(109 pages)
(109 pages)
Imprimeurs Brother HL-5240 Manuel d'utilisateur
(138 pages)
(138 pages)
Imprimeurs Brother HL-6050 Manuel d'utilisateur
(193 pages)
(193 pages)
© 2020, manymanuals.fr. Tous droits réservés | 0.975 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels