Brother Computerized Embroidery Machine Manuel d'instructions télécharger pdf (Page 33)

GETTING READY — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

While using your right hand to lightly hold the

thread passed under the thread guide plate,

pass the thread through the guides in the order

shown below.

a Shutter

Note

z If the embroidery foot has been lowered and

the shutter is closed, the machine cannot be

threaded. Be sure to raise the embroidery

foot and open the shutter before threading

the machine. In addition, before removing

the upper thread, be sure to raise the

embroidery foot and open the shutter.

z This machine is equipped with a window

that allows you to check the position of the

take-up lever. Look through this window and

check that the thread is correctly fed through

the take-up lever.

Pass the thread behind the needle bar thread

guide.

The thread can easily be passed behind the

needle bar thread guide by holding the thread

in your left hand, then feeding the thread with

your right hand, as shown.

a Needle bar thread guide

Threading the needle

This section describes how to thread the needle.

Memo

The needle threader can be used with sewing

machine needles 75/11 through 100/16.

z Thread with a thickness of 130/20 or thicker

cannot be used with the needle threader.

z If the needle threader cannot be used, refer

to “Threading the needle manually (without

using the needle threader)” (page 34).

Pull the end of the thread passed through the

needle bar thread guide to the left, and then

pass the thread through the thread guide disk

from the front.

a Thread guide disk

chapter1 Page 32 Friday, November 18, 2005 11:58 AM

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 85 86

Pas de commentaire

Brother Computerized Embroidery Machine Manuel d'instructions Page 33