Brother Computerized Embroidery Machine Manuel d'instructions télécharger pdf (Page 10)

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Needle and embroidery foot section

a Thread guide disk

Pass the thread through the thread guide disk when

using the needle threader to thread the needle.

b Needle bar thread guide

Pass the upper thread through the needle bar thread

guide.

c Needle plate

When the needle is lowered, it enters the hole in the

needle plate.

d Needle plate cover

Remove the needle plate cover to clean the bobbin case

and race.

e Bobbin cover/bobbin case

Remove the bobbin cover, and then insert the bobbin

into the bobbin case.

f Embroidery foot “Q”

This presser foot is used for embroidering.

Right-side/rear view

a Handle

Carry the machine by its handle when transporting the

machine.

b Handwheel

Turn the handwheel toward you (counterclockwise) to

raise and lower the needle.

c Embroidery card slot

Insert the embroidery card.

d Air vent

The air vent allows the air surrounding the motor to be

exchanged. Do not cover the air vent while the

machine is being used.

e Power supply jack

Insert the plug on the power supply cord into the power

supply jack.

f Main power switch

Use the main power switch to turn the machine on and

off.

Memo

z Refer to pages 8 through 11 while you are

learning to use your machine.

F-combo-BrotherE_sgml.book Page 9 Thursday, November 17, 2005 3:39 PM

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 85 86

Pas de commentaire

Brother Computerized Embroidery Machine Manuel d'instructions Page 10