Brother MFC-J4710DW Manuel d'utilisateur télécharger pdf (Page 20)

Wi-Fi Direct network terms 4

Group Owner (G/O) 4

If you set Group Owner to On, your Brother machine serves as an access point when you configure a Wi-Fi

Direct network. The G/O assigns an SSID name, password and IP address for the Wi-Fi Direct network. The

default setting is Off.

Device Information 4

Device Name 4

You can check the device name of the Brother machine in the Wi-Fi Direct network environment. The device

name will be shown as MFC-xxxx or DCP-xxxx (where xxxx is your model name.).

SSID 4

This field displays the current Wi-Fi Direct network SSID name. The display shows up to 32 characters of the

SSID name.

IP Address 4

This field displays the current IP address of the machine, as assigned by the G/O.

Status Information 4

Status 4

This field displays the current Wi-Fi Direct network status. When your machine is a G/O, it displays the

message G/O Active(**) (where ** is the number of devices). When your machine is a client, the machine

displays the message Client Active. If you see Off, your machine’s Wi-Fi Direct interface is disabled.

Signal 4

This field displays the current Wi-Fi Direct network signal strength.

Channel 4

This field displays the current Wi-Fi Direct network channel.

Speed 4

This field displays the current Wi-Fi Direct network speed.

I/F Enable 4

If you want to use the Wi-Fi Direct network connection, set I/F Enable to On.

Glossary 4

1 2 ... 15 16 17 18 19 20 21 22

Pas de commentaire

Brother MFC-J4710DW Manuel d'utilisateur Page 20