Brother MFC-7840 Guide d'installation télécharger pdf (Page 25)

Installing the Driver & Software

23

Windows

®

Windows

®

Wireless

Network

2 Plug the AC power cord into an AC outlet. Turn

the power switch on.

Improper Setup

If you have previously configured the wireless

settings of the machine you must reset the

network (LAN) settings before you can

configure the wireless settings again.

Press Menu, 5, 2, 6 (or Menu, 5, 0, 1) and then

press 1 to accept the change.

3 On your machine, press Menu, 5, 2, 2.

WLAN Enable?

1.On 2.Off

Press 1 to choose On. The wired network

interface will become inactive with this setting.

4 The machine will search for your network and

display a list of available SSIDs. You should

see the SSID you wrote down earlier. If the

machine finds more than one network use the

or to choose your network, then

press OK. Go to step 8.

Select ab or OK

salesgroup

Note

It will take several seconds to display a list of

available SSIDs.

If your access point is set to not broadcast the

SSID you will have to manually add the SSID

name. Go to step 5.

5 Select <New SSID> using the or and

press OK. Go to step 6.

Select SSID&Set

<New SSID>

6 Enter a new SSID and press OK. For

information how to type text, see Entering

text on page 46.

SSID:

7 Press the or to choose

Infrastructure, then press OK.

Mode Select

Infrastructure

8 Use the or and OK keys to choose one

of the options below: If your network is

configured for Authentication and Encryption

you must match the settings used for your

network.

No Authentication or Encryption: Choose

Open System, press OK then choose None

for Encryption Type and press OK. Then

press 1 to apply your settings. Go to step 12.

No Authentication with WEP Encryption:

Choose Open System, press OK then use the

or to choose WEP for the

Encryption Type and press OK. Go to

step 9.

Authentication with WEP Encryption:

Choose Shared Key, press OK. Go to step 9.

Authentication with WPA-PSK (TKIP or AES

Encryption): Choose WPA/WPA2-PSK,

press OK. Go to step 10.

Authentication with LEAP: Choose LEAP,

press OK. Go to step 11.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 51 52

Commentaires sur ces manuels

Pas de commentaire