Brother DCP-J925DW Guide de l'utilisateur télécharger pdf (Page 25)

Receiving a fax (MFC-J825DW only)

Remote Fax commands 4

Follow the commands below to access features when you are away from the machine. When you

call the machine and enter your remote access code (3 digits followed by ), the system will give

two short beeps and you must enter a remote command.

Remote commands Operation details

95 Change the Fax Forwarding or Fax

Storage settings

1 OFF You can choose Off after you have retrieved or erased all

your messages.

2 Fax Forwarding One long beep means the change is accepted. If you hear

three short beeps, the change was not accepted because

something has not been set up (for example, a Fax

Forwarding number has not been registered). You can

Changing your Fax Forwarding number uu page 20.) Once

you have registered the number, Fax Forwarding will work.

4 Fax Forwarding number

6 Fax Storage

96 Retrieve a fax

2 Retrieve all faxes Enter the number of a remote fax machine to receive stored

fax messages. (See Retrieving fax messages uu page 20.)

3 Erase faxes from the memory If you hear one long beep, fax messages have been erased

from the memory.

97 Check the receiving status

1 Fax You can check whether your machine has received any

faxes. If yes, you will hear one long beep. If no, you will hear

three short beeps.

98 Change the Receive Mode

1 External TAD If you hear one long beep, your change has been accepted.

2 Fax/Tel

3 Fax Only

90 Exit Pressing 9 0 allows you to exit remote retrieval. Wait for the

long beep, then replace the handset.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 75 76

Pas de commentaire

Brother DCP-J925DW Guide de l'utilisateur Page 25