Brother HL-760 Series Manuel d'utilisateur télécharger pdf (Page 36)

USER’S GUIDE

CHAPTER 4 –2

If necessary, select the interface type as follows:

1. Make sure that the printer is in the off-line state.

2. Select the RS-422A(Apple) or RS-232C(IBM) interface by changing

the serial interface slide switch to the right for IBM(RS-232C) or to the

left side for Apple (RS-422A).

Fig. 4-1 Selecting the RS-422A (Apple)

or RS-232C (IBM) Serial Interface

Setting the Serial Interface Parameters

✒ Note

This section is only for printer models which have had the serial interface

installed.

Caution

Be sure to set the parameters to match your computer as follows:

• Never change the RS-422A parameters for Apple Macintosh

computers. Because the RS-422A parameters have been correctly set at

the factory for Apple Macintosh computers, you do not need to change

the settings. You may skip this section. If you change parameters for the

RS-232C serial interface and you switch back to RS-422A for Apple

Macintosh computers, be sure to restore the parameters to the factory

settings.

• Set the RS-232C parameters to match your computer. You can set serial

settings in several different places, within your DOS application, within

the Windows Printer Icon (for Windows application software only), or

within your AUTOEXEC.BAT file using MODE commands. For

information on serial interface parameters, see the user’s guide of your

computer or software.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 80 81

Pas de commentaire

Brother HL-760 Series Manuel d'utilisateur Page 36