Brother HL-4000CN Manuel d'utilisateur télécharger pdf (Page 72)

10-5

UNIX Troubleshooting

1. Make sure that the /etc/printcap file (if applicable) is typed in correctly. In

particular, look for missing ":" and "\" characters, because a small error

anywhere in the file can have major consequences. Also check the /usr/spool

directory to make sure that you have created a valid spool directory.

2. If you are using a Linux operating system, the X-Window Print tool program

that is included with Linux may not properly configure the etc/printcap file

for lpd operation, then you might also edit the etc/printcap file and change

the following line in the entry for the printer.

:lp = /dev/null: \

then to

:lp = :\

3. If you are using a Berkeley-based UNIX, make sure that the daemon is

started on Berkeley based systems with the command lpc start printer, where

printer is the name of the local print queue.

4. If you are using an AT&T-based UNIX, make sure the printer is enabled

(enable printer, where printer is the name of the local print queue).

5. Make sure that the lpr/lpd remote line printer service are running on the host

computer (refer to your host computer documentation for information on

how to do this).

6. If you are using Sun Solaris V2.4 or earlier, there is a bug which causes long

print jobs to fail when using a print server. If you are having trouble printing

long jobs (over 1MB), add the line mx#0 to your etc/printcap file entry.

7. If you cannot print from DEC TCP/IP Service for VMS (UCX), make sure

that you have version 2.0B or later of this software, because earlier versions

will not work with print servers.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 78

Pas de commentaire

Brother HL-4000CN Manuel d'utilisateur Page 72