Brother MW-260 Manuel d'utilisateur télécharger pdf (Page 11)

1-3) Overview of document creation

A general overview of document creation is shown below.

A Switch command mode (ESC i a)

B Format settings

1． Select landscape orientation (ESC i L)

2． Initialize (ESC @)

3． Specify print area

Specify page format (ESC ( c)

Left and right margins (ESC l and ESC Q)

4． Specify line feed amount (ESC 0, ESC 2, ESC 3, and ESC A)

5． Specify tabs

Specify horizontal tab position (ESC D)

Specify vertical tab position (ESC B)

C Print operations

1． Specify print position

Specify vertical position (ESC ( v, ESC (V, VT, and ESC J)

Specify horizontal position (ESC $, ESC \, HT, and ESC a)

2． Transfer print data (1 line)

Transfer necessary text operation codes (Refer to D.) and bit images, bar

codes and downloaded data (Refer to E.).

3． End of line and feed paper (CR and LF)

4． Repeat steps 1 through 3 listed above.

5． End of page (FF)

For a page feed, specify the position where the bottom margin is exceeded

when the vertical position is specified (not with FF).

6． Printer waits and checks for ”End of Print” status. A status request is not

required.

7． Repeat steps 1 through 6 listed above.

8． End of document.

Changing the document orientation will

automatically clear the text and print

buffers. Make sure you do this before

entering any text.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 57 58

Pas de commentaire

Brother MW-260 Manuel d'utilisateur Page 11