Brother HL-1430 Guide de l'utilisateur télécharger pdf (Page 38)

1 - 26 ABOUT THIS PRINTER

After the printed transparency comes out of the printer, put in the next transparency as described

in Step 5 above. Repeat for each transparency that you want to print

After you finish the print job, close the rear cover.

Caution

Remove each transparency immediately after printing. Stacking the printed transparencies may cause

a paper jam or the transparency to curl.

■ Put the transparency into the manual feed slot with the side to be printed face up.

■ Make sure that the transparency is straight and in the proper position on the manual feed slot.

If it is not, the transparency may not be fed properly, resulting in a skewed printout or a jam.

■ Do not put more than one transparency in the manual feed slot at any one time, or it may cause

a jam.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 94 95

Pas de commentaire

Brother HL-1430 Guide de l'utilisateur Page 38