Brother CM100DM Manuel d'utilisateur télécharger pdf (Page 28)

■ Selecting and Editing the Second

Pattern

a Touch the “Add” key in the pattern layout

screen.

X The pattern category selection screen appears.

• Press to cancel the pattern selection, and

then select the pattern again.

b Select the category for the pattern to be cut

out.

a Touch to return to the previous screen.

c Select the second pattern to be used.

d Edit the pattern.

After editing is finished, touch the “Set” key.

• For details on the editing functions, see “Pattern

Editing Functions” on page 33.

e Check the pattern arrangement.

The two patterns that will be cut out appear in the

pattern layout screen. After checking the arrangement,

touch the “OK” key.

• From this screen, an individual pattern can be

edited, moved or deleted. For details on the

functions that can be used in the pattern layout

screen, see “Layout Editing Functions” on

page 35.

• By using the auto layout function, the

arrangement of the patterns can easily be

adjusted. For details, see “Auto Layout

Functions” on page 38.

X The draw/cut selection screen appears.

Note

• Depending on the pattern type and material to

be cut, the patterns may not be cleanly cut if

their spacing is too small. In that case,

rearrange the patterns to separate them.

Memo

• To move a pattern within the cutting/drawing

area, touch the pattern on the screen and drag

it to the desired position.

• To delete a pattern from the arrangement,

select the pattern in the layout editing screen,

and then use the function for deleting.

X Touch in the pattern layout screen.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 71 72

Pas de commentaire

Brother CM100DM Manuel d'utilisateur Page 28