Brother NC-4100h Guide de l'utilisateur télécharger pdf (Page 129)

CHAPTER 12 TCP/IP CONFIGURATION

12-7

Using ARP to Configure the Print Server

IP Address

If you are unable to use the Bradmin applicatio, printer front panel and your network

does not use a DHCP server, you can also use the ARP command. ARP is the

simplest method of configuring the print server IP address. The ARP command is

available on Windows systems that have TCP/IP installed as well as Unix systems.

To use arp enter the following command the command prompt:

arp -s ipaddress ethernetaddress

Where ethernetaddress is the Ethernet address (MAC address) of the print server and

ipaddress is the IP address of the print server. For example:

Windows Systems

Windows Systems require the colon ":" character in-between each digit of the

Ethernet address.

arp -s 192.189.207.2 00:80:77:31:01:07

Unix Systems

Typically, Unix systems require the hash "-" character in-between each digit of the

Ethernet address.

arp -s 192.189.207.2 00-80-77-31-01-07

You must be on the same Ethernet segment (that is, there cannot be a router between

the print server and operating system) to use the arp -s command.

If there is a router, you may use BOOTP or other methods described in this chapter

to enter the IP address.

If your Administrator has configured the system to deliver IP adresses using BOOTP,

DHCP or RARP your Brother Print Server can receive an IP address from any one of

these IP address allocation systems, in which case, you will not need to use the ARP

command. The ARP command only works once. For security reasons, once you have

successfully configured the IP address of a Brother Print Server using the ARP

command, you can not use the ARP command again to change the address. The print

server will ignore any attempts to do this. If you wish to change the IP address again,

use a Web Browser, TELNET (using the SET IP ADDRESS command) the printer

front panel (if you have an LCD panel) or factory reset the print server (which will

then allow you to use the ARP command again).

To configure the print server and to verify the connection, enter the following

command ping ipaddress where the ipaddress is the IP address of the print server.

For example, ping 192.189.207.2.

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 167 168

Pas de commentaire

Brother NC-4100h Guide de l'utilisateur Page 129